ResMed AirCurve™ 10 Vauto BiPAP Machine

On your AirCurve 10 machine, rotate the dial to highlight My Options and press the dial to see your current settings. From here, you can personalize your options.

Humidity Level

The humidifier moistens the air and is designed to make your therapy more comfortable. With the Climate Control enhanced Auto setting 3, both temperature and humidity are automatically pre-set at levels designed for maximum comfort; all you have to do is plug it in and press Start.

You can also manually set the Humidity Level to Off or between 1 and 8, where 1 is the lowest humidity setting and 8 is the highest humidity setting. (Note: If you’re using a ClimateLineAir™ heated tube, you will need to turn the Climate Control setting on your device from “Auto” to “Manual” in order to access the humidity level setting.)

If you’re getting a dry nose or mouth, turn up the humidity. If you’re getting any moisture in your mask, turn down the humidity.

How to adjust humidity:

1. In My Options, turn the dial to highlight Humidity Level and then press the dial.
2. Turn the dial to adjust the humidity level and press the dial to save the change.

Ramp Time

Ramp Time is designed to make the beginning of therapy more comfortable and is the period during which the airflow pressure increases from a low start pressure to your prescribed treatment pressure. You can set your Ramp Time to Off, from 5 to 45 minutes.

How to adjust Ramp Time:

1. In My Options, turn the dial to highlight Ramp Time and then press the dial.
2. Turn the dial to adjust the ramp time to your preferred setting and press the dial to save the change.

You should clean your machine weekly. It should take about 5 minutes, and you’ll need a sink or tub; warm, drinking-quality water (86°F / 30°C); dish soap; and a clean towel.

1. Unplug the machine. Wash the water tub and air tubing in warm water using mild detergent. Do not wash in a dishwasher or washing machine.
2. Rinse the water tub and air tubing thoroughly and allow it to dry out of direct sunlight and/or heat.
3. Wipe the exterior of the device with a dry cloth or towel.

It’s important to take regular care of your CPAP supplies which can be affected by dirt and general wear. You should regularly check the water tub, air tubing and the air filter for any damage. Here are some replacement tips for your CPAP machine parts:

Water tub:

• Replace if leaking or has become cracked, cloudy or pitted.
• Replace if the seal is cracked or torn.
• Remove any white powder deposits using a solution of one part household vinegar to 10 parts water.

Air tubing:

• Replace if there are any holes, tears or cracks.

Air filter:

• Check the air filter and replace it at least every six months.
• Replace it more often if there are any holes or blockages by dirt or dust.

The Sleep Doctor offers subscription options on most resupply items. Contact us if you have any questions.

Yes, you need a valid prescription to purchase the AirCurve 10. If you don't already have one, don't worry; we can help. After you place your order, we will connect you with one of our board-certified sleep providers for a complimentary consultation to obtain your prescription.

Yes, you need a valid prescription to purchase the AirCurve 10. If you don't already have one, don't worry - we can help. After you place your order, we will connect you with our third-party independent network of board-certified sleep providers for a complimentary consultation to obtain your prescription.